081 487 0763  This email address is being protected from spambots. You need JavaScript enabled to view it.       * FREE courier info

Shop-n-Scrap
Online Shop
Cart empty
PDFPrint

Cutting Strip - KNK Zing

Original Zing/Zing Air/Force Protection Strip
Array
Sales price R300.00
Sales price without tax R260.87
Description

If you cut too deeply and tear the cutting strip inside your machine you may want to replace it.

This thin cutting strip serves as a replacement to the strip already installed in your machine and is only compatible with the KNK 14" machines (Zing, Zing Air)

 

Zing/Zing Air/Force Protection Strip

 

Removing the Old Cutting Strip - Peel off the clear plastic layer from the current cutting strip on your machine and remove the entire adhesive layer. Use rubbing alcohol or other adhesive remover on a cotton swab or paper towel to wipe off any residual adhesive or debris from the cutting strip area.

Applying the New Cutting Strip - Peel back approximately half of the release liner of the new cutting strip and fold it over to the other half of the release liner. Adhere the cutting strip starting from the left side of the machine (adhesive side down) along the front edge of the groove. Make sure to leave a small gap between the cutting strip and the left edge of the groove. Pass the right end of the cutting strip underneath the carriage and then move the carriage to the left-hand side of the machine. Peel off the remaining release liner and then adhere the rest of the cutting strip in the groove. Ensure that the cutting strip is applied so that it continues to lay flat and straight.

CONTACT US

   081 487 0763                                     

orders@shop-n-scrap.co.za

Collect in Waterkloof Ridge, Pretoria (only with an online order number)